[1]杭声琪,张文韬,王泰淇,等.基于CT和MRI膝关节有限元模型建立与不同载荷下生物力学特性分析[J].中国医学物理学杂志,2021,38(3):370-374.[doi:DOI:10.3969/j.issn.1005-202X.2021.03.019]
　HANG Shengqi,ZHANG Wentao,WANG Taiqi,et al.Establishment of finite element model of knee joint based on CT and MRI and analysis of biomechanical characteristics under different loads[J].Chinese Journal of Medical Physics,2021,38(3):370-374.[doi:DOI:10.3969/j.issn.1005-202X.2021.03.019]
点击复制

基于CT和MRI膝关节有限元模型建立与不同载荷下生物力学特性分析()
分享到：

《中国医学物理学杂志》[ISSN:1005-202X/CN:44-1351/R]

卷:
38卷
期数:
2021年第3期
页码:
370-374
栏目:
生物材料与力学
出版日期:
2021-03-30

文章信息/Info

Title:
Establishment of finite element model of knee joint based on CT and MRI and analysis of biomechanical characteristics under different loads
文章编号:
1005-202X（2021）03-0370-05
作者:
杭声琪1; 张文韬2; 王泰淇1; 任建澄1; 李富超1; 赵改平1; 马童3
1.上海理工大学医疗器械与食品学院， 上海 200093； 2.上海理工大学环境与建筑学院， 上海 200093； 3.同济大学附属杨浦区中心医院骨科， 上海 200090
Author(s):
HANG Shengqi1;  ZHANG Wentao2;  WANG Taiqi1;  REN Jiancheng1;  LI Fuchao1;  ZHAO Gaiping1;  MA Tong3
1. School of Medical Instrument and Food Engineering, University of Shanghai for Science and Technology, Shanghai 200093, China 2. School of Environment and Architecture, University of Shanghai for Science and Technology, Shanghai 200093, China 3. Department of Orthopedics, Yangpu Hospital Affiliated to Tongji University, Shanghai 200090, China
关键词:
计算机断层扫描; 磁共振成像; 膝关节; 生物力学特征; 内外翻力矩; 接触应力; 六面体网格; 有限元分析
Keywords:
Keywords: computed tomography magnetic resonance imaging knee joint biomechanical characteristics varus and valgus torques contact stress hexahedral mesh finite element analysis
分类号:
R318
DOI:
DOI:10.3969/j.issn.1005-202X.2021.03.019
文献标志码:
A
摘要:
基于CT和MRI图像数据建立膝关节有限元模型，采用六面体网格对不同载荷系统下人体膝关节生物力学特性进行研究，并进行有效性验证。建立膝关节有限元模型包括：股骨、胫骨、髌骨、腓骨、股骨软骨、胫骨软骨、腓骨软骨、半月板、前后交叉韧带、内外侧副韧带、髌韧带和股四头肌腱等。对膝关节施加1 kN轴向压缩载荷、134 N后向抽屉力和5、10、15 N[?m内翻力矩和外翻力矩，分析膝关节内软骨和半月板的接触应力和接触面积，股骨内外翻倾角以及位移变化情况。在1 kN压缩载荷和134 N抽屉力作用下，股骨软骨、内外侧半月板和内外侧胫骨软骨的接触应力峰值分别为4.47、3.25、2.83、2.70、2.53 MPa，Von Mises应力峰值分别为2.22、2.44、2.25、2.07、1.64 MPa。股骨相对胫骨前向位移为4.19 mm。施加5、10、15 N[?m内翻和外翻力矩时，股骨内翻和外翻倾角分别为3.49°、4.48°、4.91°和3.22°、3.62°、4.01°。随着力矩的线性增大，膝关节各组成部分的应力呈非线性变化趋势。膝关节软骨、半月板和韧带的研究结果符合其生物力学特性，与前人数值分析和实验研究结果相一致，可为临床膝关节生理病理分析和治疗提供一定的理论依据。
Abstract:
Abstract: Based on CT and MRI image data, a finite element model of the knee joint is established, and hexahedral mesh is used to analyze the biomechanical characteristics of human knee joint under different loads, thereby verifying the validity of the model. The established knee joint finite element model includes femur, tibia, patella, fibula, femoral cartilage, fibula cartilage, meniscus, anterior and posterior cruciate ligament, medial and lateral collateral ligament, patellar ligament and femoral quadriceps tendon. After the knee joint is applied with 1 kN axial compression load, 134 N in posterior drawer test, and 5, 10, 15 N·m varus and valgus torques, the contact stress and contact area of the internal cartilage and the meniscus of the knee joint, femoral varus angles and valgus angles are analyzed, and the displacement of the knee joint is measured. Under 1 kN compression load and 134 N in drawer test, the peak contact stresses of femur cartilage, medial and lateral meniscus, and medial and lateral tibial cartilage are 4.47, 3.25, 2.83, 2.70 and 2.53 MPa, respectively, with peak Von Mises stresses of 2.22, 2.44, 2.25, 2.07 and 1.64 MPa, respectively. The displacement of femur relative to tibia is 4.19 mm. When applying 5, 10 and 15 N·m varus and valgus torques, femoral varus and valgus angles are 3.49°, 4.48°, 4.91°, and 3.22°, 3.62°, 4.01°, respectively. With the linear increase of torque, the stress of each component of the knee joint presents a nonlinear change trend. The analysis results of knee articular cartilage, meniscus and ligaments are in accordance with their biomechanical properties, which is consistent with the previous results of numerical analysis and experimental studies. The established model can provide a certain theoretical basis for the physiological and pathological analyses on knee joint and its treatment research.

相似文献/References:

[1]王水花,张煜东.压缩感知磁共振成像技术综述[J].中国医学物理学杂志,2015,32(02):158.[doi:10.3969/j.issn.1005-202X.2015.02.002]
[2]马海涵,游 箭,唐文国,等.成人小脑髓母细胞瘤MR成像和NSE表达水平[J].中国医学物理学杂志,2015,32(02):207.[doi:10.3969/j.issn.1005-202X.2015.02.012]
[3]武 杰,袁航英,严 峻,等.医用核磁共振成像设备的风险因素分析与管理[J].中国医学物理学杂志,2014,31(03):4918.[doi:10.3969/j.issn.1005-202X.2014.03.016]
[4]张煜东,王水花.磁共振成像加速方法[J].中国医学物理学杂志,2014,31(04):5015.[doi:10.3969/j.issn.1005-202X.2014.04.010]
[5]万俊,聂生东,王远军,等.基于MRI的脑肿瘤分割技术研究进展[J].中国医学物理学杂志,2013,30(04):4266.[doi:10.3969/j.issn.1005-202X.2013.04.013]
[6]曾雁冰,张战胜,辛学刚,等.反演法在磁共振射频场设计与优化中的应用[J].中国医学物理学杂志,2013,30(04):4272.[doi:10.3969/j.issn.1005-202X.2013.04.014]
[7]赵 琳,张军,张新宇,等.CT和MRI诊断脑神经胶质瘤52例分析[J].中国医学物理学杂志,2015,32(04):464.[doi:10.3969/j.issn.1005-202X.2015.04.003]
　[J].Chinese Journal of Medical Physics,2015,32(3):464.[doi:10.3969/j.issn.1005-202X.2015.04.003]
[8]赵 琳,张军,张新宇,等.CT和MRI诊断脑神经胶质瘤52例分析[J].中国医学物理学杂志,2015,32(04):464.[doi:10.3969/j.issn.1005-202X.2015.04.003]
[9]骆众星,石健强,谢斯栋,等.T1 FLAIR PROPELLER序列在3.0T磁共振颅脑增强成像上对抑制各种伪影的应用[J].中国医学物理学杂志,2015,32(06):878.[doi:doi:10.3969/j.issn.1005-202X.2015.06.025]
　[J].Chinese Journal of Medical Physics,2015,32(3):878.[doi:doi:10.3969/j.issn.1005-202X.2015.06.025]
[10]管春,朱庆永.参考制导的压缩感知快速磁共振重建方法[J].中国医学物理学杂志,2016,33(3):217.[doi:10.3969/j.issn.1005-202X.2016.03.001]

备注/Memo

备注/Memo:
【收稿日期】2020-10-23 【基金项目】国家自然科学基金（11502146）；上海市自然科学基金（15ZR1429600） 【作者简介】杭声琪，硕士研究生，研究方向：生物力学，E-mail: hangshenqi@foxmail.com 【通信作者】赵改平，副教授，硕士生导师，E-mail: zgp_06@126.com
更新日期/Last Update: 2021-03-30